Weeping Wall

Offering a solution to farmers on effluent screening , RX Plastics has developed a weeping wall using a triangular shaped profile of PVC.  Traditionally weeping walls have been made from timber, which has a disadvantage of swelling under wet conditions and shrinking under dry conditions .  This causes the spacings in a weeping wall to be inconsistent in turn allowing solids to pass through the screen. The introduction of the PVC effluent bar as a medium has provided a product that does not break down over time, does not swell or shrink and provides a consistent gap for solids removal.

The design of differing gaps between profiles and various sized panels makes this an ideal solution to a variety of pond styles and effluent types.  The triangular bar gives a higher physical strength to the wall and the shape allows efficient liquid flow while holding back solids. 

Download Weeping Wall brochure 

weeping-wall weeping_wall_used weeping_wall_used2

Size

Selecting Gap Size

4mm Gap

  • Hosing straight off a yard or flood wash
  • Low fibrous material
  • Relatively high water content

6mm Gap

  • Hosing straight off a yard or flood wash
  • Average / normal fibrous material
  • Average / normal water content

8mm Gap

  • For use inn feed lots where the yards are scaped to clean
  • High fibrous material
  • Relatively low water content

How many panels do you need?

  • Rule of thumb is 1 panel per 100 cows would be needed per drying bed

 

CODE GAP WIDTH HEIGHT
KLWEEP610.2000.4MM 4mm gap 610mm 2000mm
KLWEEP610.2000.6MM 6mm gap 610mm 2000mm
KLWEEP610.2000.8MM 8mm gap 610mm 2000mm
KLWEEP1000.1500.4MM 4mm gap 1000mm 1500mm
KLWEEP1000.1500.6MM 6mm gap 1000mm 1500mm
KLWEEP1000.1500.8MM 8mm gap 1000mm 1500mm
KLWEEP1200.1200.4MM 4mm gap 1200mm 1200mm
KLWEEP1200.1200.6MM 6mm gap 1200mm 1200mm
KLWEEP1200.1200.8MM 8mm gap 1200mm 1200mm